Würth Master WDM 101 Instrucciones Para El Manejo página 19

All manuals and user guides at all-guides.com
WDM 101 - Buch Seite 19 Dienstag, 8. Januar 2008 1:36 13
Mark-out Function
D
For uniform marking of distances, two clear-
ances a and b can be entered and saved. In the
following measurement, the currently measured
distance is compared with the clearance a and
the difference is shown on the display.
– Press button four times. The mark-out
function symbol appears on the display and
measure a flashes.
– Enter measure a with buttons
save with button .
– Afterwards, enter measure b and save. The
laser beam is activated.
– Align the laser beam and move the device
while watching the display. The arrows on
the display indicate in which direction the
device is to be moved.
– When the acoustic signal changes and
0.000 is indicated, the measuring value at
the rear stop/rest corresponds with meas-
ure a. Mark this point.
– Move the device further towards the measure
a + b and mark the second determined point.
The next measure to be determined is now at
a + b + b etc.
The next measured value is displayed in the bot-
tom intermediate indication.
The function can be ended by pressing the
button. The saved measures a and b are retained.
Indirect Measurement using the
Pythagoras' Theorem
E
The device can determine a distance based on
auxiliary measurements in accordance with the
mathematical Pythagoras' theorem. This is use-
ful when a direct measurement cannot be taken.
The measured points must be in one line.
The measuring sequence shown in figures
must be adhered to.
Best results are achieved when the device is
turned around a firm point. As an example,
place the device against a wall and turn it
around the completely folded out stop/rest
angle.
Use the tracking function to determine the small-
est distance rectangular to the target and the
greatest distance for the other measurements.
The automatic release/timer can be used.
Values from the memory can be called up.
Pythagoras I – Determining
a Distance with 2 Auxiliary
Measurements
– Press pushbutton
appears in the display. The laser is activated.
– Aim at the upper measuring point and initi-
ate measurement 1 by pressing button
– Hold the unit as horizontal as possible. To initi-
and
ate continuous measuring, press and hold but-
ton . When the rapid beep sounds, circle
generously around measuring point 2. Press
button to end the measurement.
The auxiliary measurements and result l are
indicated in the display.
Pythagoras II – Determining
a Distance with 3 Auxiliary
Measurements
– Press pushbutton
appears in the display. The laser is activated.
– Aim at the upper measuring point and initi-
ate measurement 1 by pressing button
– Hold the unit as horizontal as possible. To initi-
ate continuous measuring, press and hold but-
ton . When the rapid beep sounds, circle
generously around measuring point 2. Press
button to end the measurement.
– Aim at the bottom measuring point and initi-
ate measurement 3 by pressing button
The auxiliary measurements and result l are
indicated in the display.
Pythagoras III – Determining a
Partial Distance with 3 Auxiliary
Measurements
– Press pushbutton
appears in the display. The laser is activated.
– Aim at the upper measuring point and initi-
ate measurement 1 by pressing button
– Aim at the center measuring point and initi-
ate measurement 2 by pressing button
– Hold the unit as horizontal as possible. To ini-
tiate continuous measuring, press and hold
button . When the rapid beep sounds, cir-
cle generously around measuring point 2.
Press button to end the measurement.
until the symbol
.
until the symbol
.
.
until the symbol
.
.
19