Environmental Protection; Declaration Of Conformity - Würth Master WDM 101 Instrucciones Para El Manejo

All manuals and user guides at all-guides.com
WDM 101 - Buch Seite 21 Dienstag, 8. Januar 2008 1:36 13
Warranty
For this Würth tool, we provide a warranty in
accordance with statutory/country-specific reg-
ulations from the date of purchase (proof of pur-
chase by invoice or delivery note). Damage that
has occurred will be corrected by replacement
or repair.
Damage caused by normal wear, overloading
or improper handling is excluded from the war-
ranty.
Claims can be recognised only when the tool is
presented undisassembled to a Würth branch
office or a Würth field service employee.

Environmental Protection

Recycle raw materials instead of dis-
posing as waste.
Machine, accessories and pakkaging
should be sorted
ment-friendly recycling.
The plastic components are labelled for catego-
rized recycling.
Declaration of
Conformity
We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization
EN 55 022, IEC 61 000-4-2, IEC 61 000-4-3,
IEC 61 000-4-8 according to the provisions of
the regulations 89/336/EEC, 2004/108/EC.
07
Adolf Würth GmbH & Co. KG
P. Zürn R. Bauer
FCC statement (applic. in U.S.)
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a res-
idential installation.
This equipment generates, uses and can radiate
radio freqency energy and, if not installed and
used in accordance with the instructions, may-
cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
for environ-
- Increase the separation between the equip-
ment and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV
technician for help.
WARNING:
Changes
approved by Würth for compliance could void
documents:
the user's authority to operate the equipment.
Product labelling:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interfer-
ence, and 2) this device must accept any inter-
ference received, including interference that
may cause undesired operation.
Subject to change without notice
or modifications not expressly
21