Tower Mounting - Tripp-Lite AG-0358 Serie Manual Del Propietário

Installation
2-Post Mounting
If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post Rack-Mount Installation Kit (model:
2POSTRMKITWM, sold separately). See Installation Kit owner's manual for installation procedure.

Tower Mounting

Your UPS can be mounted in an upright tower position with optional
base stands sold separately by Tripp Lite (model: 2-9USTAND).
When mounting the UPS on adjustable base stands, make sure the
LCD panel is facing toward the top.
WARNING!
All UPS systems are extremely heavy. Use caution
when lifting and mounting. User must properly
stabilize the UPS when lifting and mounting.
The LCD panel may be rotated for easier viewing while the UPS is
upright. To rotate, insert a small screwdriver or other flat-edge tool
into the slots on any side of the LCD panel. Pop the panel out,
rotate accordingly and snap it back into place.
WARNING: Display circuitry is not isolated. Display
rotation must be performed by qualified electrical
service personnel.
EXTERNAL BATTERY CONFIGURATION NOTE
If external battery packs are to be used with this UPS, install them following the mounting/installation documentation included with each
battery pack.
These SmartOnline UPS systems support automatic detection of up to four compatible Tripp Lite Smart battery packs. Each Smart battery
pack includes a wired data connection that enables automatic detection and configuration for up to four Smart external battery packs to
the UPS. If more than four external battery packs need to be configured, all packs must be configured via the Tripp Lite external battery
configuration software connecting though the UPS serial port. In this configuration, do not connect the Smart battery communication cables
to any of the external battery packs.
9