Installation - Tripp-Lite SmartOnline SU750XL Manual Del Usuario

Installation

Connection and Start-Up
1
Plug your UPS line cord into an
electrical outlet.
Your UPS must be connected to a dedicated
circuit of sufficient amperage. However, the
select models may be fitted with different plug
types. Refer to the "OP Rating/Plug Rating" chart
printed on the top of your UPS.
Once your UPS is plugged in, the fan and all
Indicator Lights will turn ON. The "LINE" and
"LOAD ACTIVE METER" LEDs will illuminate and
the UPS will beep to indicate normal operation.
However, power is not supplied to your UPS AC
outlets until the UPS is turned on.
2
Plug your equipment into your UPS.
Your UPS is designed to support computer
equipment only. You will overload your UPS if
you connect household appliances or laser
printers to the UPS outlets.
3
Turn your UPS ON:
• Press the "ON/TEST" Button
• Hold it for several seconds until you hear a
beep
• Release it
Your UPS will begin providing AC power to its
outlets. The "ON LINE" LED will illuminate.
Note: UPS system will function properly upon initial
startup; however, maximum runtime for the unit's
battery will only be accessible after it has been
charged for 24 hours.
Optional Connections
Your UPS will function properly without these connections.
1
Phone Line or Phone/Network Line
Surge Suppression
Your UPS has jacks which protect against
surges on a phone or network line.* Using
appropriate network cords, connect your wall
jack to the UPS jack marked "IN." Connect your
equipment to the UPS jack marked "OUT."
Make sure the equipment you connect to the
UPS jacks is also protected against surges on
the AC line.
* Not compatible with PoE (Power Over Ethernet)
applications.
17-05-031-932470.indb 4
Your model may differ.
1
Your model
may differ.
2
3
Your model
may differ.
1
4
5/23/2017 1:52:05 PM