Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pocket Transmitter for
Audio Transmission
These instructions are intended for users without
any specific technical knowledge Please read
the instructions carefully prior to operation and
keep them for later reference
1 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally in-
tended, if it is not correctly operated, or if it
is not repaired in an expert way
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment
2 Applications
Combined with the JTS receiver R-4 / 5, the
pocket transmitter R-4TBM / 5 creates a wireless
audio transmission system The REMOSET
tion is a most convenient feature for operating
the system: Simply press a button and, via a
2 4 GHz radio signal, the pocket transmitter is
matched to the transmission frequency selected
on the receiver
For audio transmission, a microphone is
required A wide range of microphones is avail-
able from JTS: All microphones with a 4-pole
mini XLR plug are suitable
2.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the pocket transmitter R-4TBM / 5 complies
with the directive 2014 / 53 / EU The EU declara-
tion of conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
In the Federal Republic of Germany, the pocket
transmitter R-4TBM / 5 requires a frequency
assignment (for which a fee is charged)
In other countries, it is necessary to apply
for a corresponding approval Prior to operat-
ing the system outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to
the national authorities can be found via the
following Internet address:
www cept org
t ECC
t Topics
t Other spectrum topics: SRD Regulations
and indicative list of equipment sub-classes
t EFIS and National Frequency Tables
3 Operation
3.1 Inserting or replacing the batteries
For power supply, two 1 5 V batteries of size
AA are required If the LED
batteries are discharged and should be replaced
•
Only insert batteries of the same type and
always replace both of them
•
If the transmitter is not in use for a longer
period of time, always remove the batteries
func-
®
as a precaution to prevent damage due to
battery leakage
1) Push down the unlock button (6) to open the
battery compartment cover (7)
2) Insert the batteries with the positive and
negative poles as indicated in the battery
compartment
3) Close the battery compartment cover so that
it is locked
CZ
DE
EL
IT
LT
MT
(2) shows red, the
FI
FR
PL
13
Publicidad
Capítulos
Tabla de contenido
