Setting The Transmission Frequency; Remoset Function; Identification Number - Monacor JTS R-4TBM/5 Manual De Instrucciones

between 0 and 20 Press the button SET to
save the setting The main menu reappears
To deactivate the main menu, press the
button or to change another setting, press
the button  or  to select the correspond-
ing menu item and press the button SET
2) To set the time for the display backlight, go
to the menu item
Light Time
15 Sec.
= no backlight
Always OFF
– = time in seconds
5 30 Sec.
= backlight always on
Always ON
Hint: To save the batteries, it is advisable not to use
as a permanent setting
Always ON
3) For a reset to the factory settings, select the
menu item
Reset
A message appears to warn you that reset-
ting will erase any data stored:
All stored
data will be
erased.
Yes / No
Fig. 6
To cancel the process, retain the option
and press the button SET; to reset, use the
button  to select
ton SET

3.7 Setting the transmission frequency

Before switching on the pocket transmitter, set
the receiver to an interference-free frequency
(refer to the instruction manual of the receiver)
Then set the transmitter to the same frequency
There are three methods to do this:
1 If you operate the pocket transmitter together
with the receiver R-4 / 5, the easiest way is to
use the patented REMOSET function When
you press the button REMOSET on the re-
ceiver, the transmitter is set to the trans-
mission frequency selected on the receiver
(chapter 3 7 1)
2 The transmission frequency can be ad-
justed manually between 506 000 MHz and
542 000 MHz (chapter 3 7 2)
3 For operating multiple audio transmission sys-
tems at the same time, there are 6 groups
:
Light Time
Fig. 5
and press the button SET
and press the but-
Yes
with up to 22 channels in each group (refer
to the table on page 35) In ideal condi-
tions, all channels from a group can be used
for audio transmission at the same time If
the receiver has been set to a channel from
these groups, select the same channel for the
pocket transmitter (chapter 3 7 3)

3.7.1 REMOSET function

For the REMOSET function always make sure
that
1 no menu is called up on the pocket transmit-
ter or on the receiver
2 the transmitter is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the transmitter and the receiver are set to
the same identification number (ID No ) or
that the function ID No is deactivated (see
paragraph "Identification number")
4 the REMOSET function is not disabled (see
paragraph "Disabling the REMOSET func-
tion")
– Identification number –
To prevent mutual interference of individual
No
pairs of transmitter / receiver during REMOSET
transmission, each pair must have a different
identification number (ID No ) If you only use
one pair of transmitter / receiver, there is no need
to change the preset ID No 1 To change the
ID No :
1) Call up the setting for the ID No via the
menu item
Remoset ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button
 to deactivate the function (OFF) or the
button  to activate the function (ON) If the
function has been deactivated, the REMOSET
transmission will be possible from any R-4 / 5
receiver; if the function has been activated,
the REMOSET transmission will only be pos-
sible from a receiver with the same ID No
4) Press the button SET to save the setting
of the main menu
Remoset ID
Fig. 7
15