Canon PIXMA MX700 Serie Guía De Configuración página 11

If "Communication with the Card Slot failed." is
displayed, click Retry. If it still fails, click Skip to
complete the setup. Then try the network setup of
the Card Slot using the Canon IJ Network Tool.
Note
If "Cannot map any more drives, because all the
drive letters are assigned." is displayed, click Skip
to complete the setup. After software installation is
complete, remove any drive letter and try the
network setup of the Card Slot again using the
Canon IJ Network Tool. For details, refer to "Using
the Card Slot over a Network" in the User's Guide
on-screen manual.
If "The Card Slot is already mapped as Network
Drive to this computer." is displayed, the Card Slot
is already set up. Click OK, then click Next.
7
When the Setup Completion dialog box
appears, remove the USB cable, then click
Finish.
The network connection between the machine and
the computer is now successfully established.
To confirm the setup results, click View Setup
Results.
Note
To change the port name, click View Setup
Results, then click Set Port Name on the
Setup Results dialog box. For details
"Changing the Port Name" in "Troubleshooting" in
the User's Guide on-screen manual
If "Unsafe Removal of Device" is displayed, click
OK.
8
When the Setup Complete screen appears,
click Next.
, refer to
.
9