Setup; Console Setup; Connecting External Monitor - Sunoptic Surgical HDC-300 Manual De Instrucciones

Sistema de cámara hd
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 87

4. SETUP

4.1.

Console Setup

Place the camera console on a stable surface (cart, counter, stand, etc.).
WARNING: DO NOT place console in an area where it can be exposed to liquids.
WARNING: DO NOT use in any environment with explosive or flammable gases.
WARNING: DO NOT obstruct the bottom intake or rear exhaust vents of the camera console.
5" or approx. 13mm clearance is required above and behind the console for adequate airflow.
The console should not be placed in which its exhaust can interfere with other devices, nor
should it be placed near any heat generating devices.
4.2.
Connecting Camera Head
CAUTION: THE CAMERA CABLE SHOULD BE CONNECTED AND DISCONNECTED BY
GRASPING FROM THE RIGHT-ANGLE CONNECTOR ONLY. PULLING BY THE CABLE
MAY DAMAGE THE DEVICE (THIS DAMAGE IS NOT COVERED BY PRODUCT
WARRANTY).
Connect the camera head to the console by first aligning the red dot located on the right-angle
connector with the red dot located on the console front panel receptacle. Insert firmly until the
right-angle connector is fully seated.
4.3.

Connecting External Monitor

The camera console has (4) video output connections located on the rear panel. All (4) outputs
may be used simultaneously. Please refer to the rear panel diagram for a description of each
output.
LIT- 248 SUNOPTIC SURGICAL
Rev. D
®
Page 10 of 189
(English)

Publicidad

Tabla de contenido
loading

Tabla de contenido