Optical Alignment - Johnson Controls PG9200AX Manual Del Usuario

Optical Alignment

After mounting, perform an optical alignment to ensure the device functions reliably.
Alignment angles
Callout Component
A Horizontal alignment angle
B Vertical alignment angle
Aligning the device
1. Ensure the beam frequency selector positions of the paired transmitter and receiver are the same. See
the 4-channel beam frequency selector section.
2. While looking through the view finder, adjust the horizontal and vertical angles so that the pairing
detector is at the center of the sight.
a. For rough alignment of the horizontal angle, hold and move the lens to the left or right.
For fine alignment of the horizontal angle, turn the horizontal alignment dial.