Danby Silhouette Professional DIM32D1BSSPR Instrucciones De Uso página 7

CONNECTING ICE MAKER TO DRAIN
Drain pipe connection (drain hose not provided)
• You will need to purchase the external drain pipe, available at your local hardware store. The connection instructions
are as follows: Choose drain option A, B or C
outlet of the ice maker, and put the other side of the drain pipe into a drain hole (see Fig E).
A - Is a drain pump option
B - Is a continuous drain option
C - Is a manual drain option (meaning there is no drain hole in the room). We recommend this option for tem-
porary use.
NOTE: When using drain pump "A," the switch (on back) must be turned to the "ON" position during operation.
Your ice maker has three different drain types, you can choose the most suitable mode according to your require-
ments. See detailed instructions on the following page.
INSTALLATION INSTRUCTIONS
WARNING
Please disconnect unit from power and make sure
no water is near the ice maker or fl oor board to
avoid electric shock before following the steps
below.
(see below,)
WARNING
Please read the following instructions before using
this appliance. Choose the correct drain mode
according to your preference and set up your
appliance accordingly.
IMPORTANT
When installing the unit DO NOT kink the drain
hose!
IMPORTANT
Make sure that you connect the ice maker drain to
your household drain in accordance with all Federal
and local codes and ordinances. This ice maker
provides three types of draining system, follow
these guidelines when installing the drain lines.
insert a washer between drain pipe and the chosen drain
5