Lenco CRW-110WH Manual De Usuario página 15

Descriptions
Light mode
Light brightness
Display brightness
CLOCK
Time setting
When the alarm clock is connected to power for the first time, the display flashes.
1. When the hours flash, use
2. When the minutes flash, use
3. will display, use
4. To restart the time setting mode, long press
above.
Note: if there is no operation for 10 seconds in time setting mode, it will exit automatically without saving
Display brightness
Press to choose display brightness: low, high or off. Default is high.
ALARM
Alarm time setting
Functions
Turn on the light
Turn off the light
1. Green light
2. Red light
3. Blue light
4. Pink light
5. Orange light
6. Light blue light
7. Color changing automatically
Adjust the light brightness
Turn off the time display
In low display brightness
In high display brightness
BUTTONS CONTROL
or to set the hours. Press
or to set the minutes. Press
or select network timing or not. Press
Ok google, turn on "the device"
OK google, turn off "the device"
Ok google, set "the device" to green
Ok google, set "the device" to red
Ok google, set "the device" to blue
Ok google, set "the device" to pink
Ok google, set "the device" to orange
Ok google, Set "the device" to light blue
Ok google, set "the device" to auto color
Ok google, set "the device" to 0-100 percent
Ok google, set "the device" screen mode to
off
Ok google, set "the device" screen mode to
low
Ok google, set "the device" screen mode to
high
to confirm and continue.
until the hours start to flash and repeat setting as mentioned
15
Voice Commands
to confirm and continue.
to confirm.