Measurement Modes; Using The Softkeys - Mettler Toledo SevenGo Duo pro SG68 Instrucciones De Manejo

READ/BACKLIGHT
CAL
MODE or EXIT

Measurement modes

A single channel has to be selected first in order to switch the measurement mode.
Press and release the MODE key in the single channel display to change between the different
measurement modes.
Press and hold the MODE key to switch between the dual and single channel measurement screen.
The sequence of the alternating measurement modes for pH/ion measurement is:
1. pH
2. mV
3. rel. mV
4. ion
For the DO measurement the sequence is:
1. saturation (%)
2. ppm
3. mg/L

4.4 Using the softkeys

The SevenGo Duo pro™ multi-parameter meter has three softkeys. The functions assigned to them change
during operation depending on the application. The assignment is shown on the bottom line of the screen.
In the measurement screen, the three softkeys are assigned as follows:
Menu
Access meter settings
The other softkey functions are:
SevenGo Duo pro™
Start or endpoint measurement
(measurement screen)
Confirm input or start editing a table
Exit setting and go back to measurement
screen
Start calibration
Switch mode in single channel
(measurement screen)
Discard setting and go back to previous
menu (setting screens)
Save an endpointed measurement
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in memory
Delete letters or numbers on
alphanumeric keypad
Turn backlight on or off
Review the last calibration data
Switch between single and dual channel
display (measurement screen)
Store
Access data menu
Edit table or value
Edit
End End calibration
Confirm
Yes
No Reject
Review Review selected data
Save data, setting or value
Save
Select Select the highlighted function or
setting
Start Begin the reference measurement
Operating the pH/ORP/Ion/DO meter SG68​ ​ 11
Data