Setup; Menu Structure Of Setup; Sample Id; User Id - Mettler Toledo SevenGo Duo pro SG68 Instrucciones De Manejo

5 Setup

5.1 Menu structure of setup

The individual items of the menu setup are described on the pages following the list below.
1.

Sample ID

1. Enter Sample ID
2. Select Sample ID
3. Delete Sample ID
2.

User ID

1. Enter User ID
2. Select User ID
3. Delete User ID
3.

Data Logging

1. Automatic Storage
2. Manual Storage
3. Timed Interval Readings
5.2 Sample ID
An alphanumeric sample ID with up to 12 characters can be entered. Alternatively, a previously entered
sample ID can be selected from the list. If a sample ID has been entered, which is either purely numeric (for
example, 123) or ends with a number (for example, WATER123), the following options are available:
1. <Auto Sequential> On
Using this setting will automatically increment the sample ID by 1 for each reading.
2. <Auto Sequential> Off
The sample ID is not incremented automatically.
A maximum of 5 sample IDs are stored in memory and listed for selection. If the maximum of 5 has already
been entered, a sample ID can either be deleted manually or the oldest ID will be automatically overwritten by
the new ID.
5.3 User ID
A user ID with up to 8 characters can be entered. Alternatively, a previously entered user ID can be selected
from the list.
A maximum of 5 user IDs are stored in memory and listed for selection. If the maximum of 5 has already been
entered, a user ID can either be deleted manually or the oldest ID will be automatically overwritten by the new
ID.
5.4 Data logging
The meter stores up to 500 sets of measurement data in the memory. The number of data sets already stored
in the memory is indicated by MXXX on the display. A message appears on the display when the memory is
full. To save further measurements if the memory is full, data has to be deleted first. When measuring in dual
channel mode, both results will be stored separately. Therefore, the memory number in this case will increase
by 2. You can select between automatic and manual storage or you can log your data into the memory in a
user-defined interval:
1. Automatic storage
Stores every endpointed reading to the memory automatically.
2. Manual storage
If "Manual Storage" is set, Store appears on the display. Press Store to save endpointed readings.
16 Setup​ ​
4.

System settings

1. Language
2. Time and Date
3. Access Control
4. Acoustic Signal
5. Routine/Expert Mode
6. Screen Settings
5. Instrument Self-test
1. Screen Contrast
2. Auto-Shutoff
3. Backlight Off
SevenGo Duo pro™