Parameter Setting - ChefLine TN40 Manual De Uso Y Mantenimiento

4. LOWER RESISTORS OPERATION SYMBOL: it is activated when the upper resistors are on to bring the detected
temperature up to the bottom set point;
5. CONVEYOR SPEED: displayed minutes and seconds, corresponds to the cooking time in the chamber.
6. DIRECTION CONVEYOR ROTATION: if the arrow is to the left, the food is cooked from right to left, if the arrow is to
the right, the food is cooked from left to right.
7. CONVEYOR OPERATION SYMBOL: it moves when the conveyor is in operation. It is only indicative and does not
vary with respect to the set speed.
8. DATE AND TIME
9. PROGRAM SELECTION LINE: starting from the manual (M), 6 programs selectable by means the right and left
direction keys, functioning when the ENTER key is pressed. The program in use is highlighted.

Parameter setting

TEMP KEY (2)
When pressed, the parameter to be set starts to flash in the following order:
- UPPER TEMPERATURE SETPOINT;
- LOWER TEMPERATURE SETPOINT;
- CONVEYOR SPEED
When pressed a fourth time, the setting screen is exited and the set parameters are confirmed. Alternatively, you can exit
and confirm without going through all the parameters by pressing the ENTER key or wait a few seconds.
The settings are always saved automatically.
MENU KEY (3)
When pressed, you enter the menu with the list of items:
- PROGRAMS
- SCHEDULER
- DATE/HOUR
- CONVEYOR DIRECTION
- LANGUAGE
- MAINTENANCE MENU
- EXIT
The navigation is done through the arrows (KEYS 5 and 6), to enter the corresponding item press the ENTER key, to exit
the menu go to the exit item and press ENTER.
ENTER KEY (4)
If pressed in the main screen, it has the function of starting or stopping the conveyor. If you are in the parameter or menu,
the parameter is saved.
RIGHT ARROW KEY (5)
Navigate to the right by scrolling through the programs on the main screen line; if in the parameter configuration, increase
the value or select the next item.
LEFT ARROW KEY (6)
Navigate to the left by scrolling through the programs on the main screen line; if in the parameter configuration, decrease
the value or select the next item.
ON/OFF KEY (7)
Turn on the card or puts it in standby port when turned on.
71