Carpet Cleaning; Above Floor Cleaning/Attachments - Hoover fh50800 Manual Del Propietário

Carpet CleaninG

2.10 Plug cord into electrical outlet. Step on handle
release pedal, to put unit in cleaning position.
2.11 Press the ON/OFF pedal and turn "ON".
IMPORTANT
To avoid saturating carpet, do not use more
than 4 wet strokes over one area. Always end
with dry strokes.
2.12 While depressing solution spray trigger (A),
slowly push unit forward. Release trigger and pull
unit backward (B) in the same path to remove dirty
water and solution from carpet. (For heavily soiled
areas, repeat if necessary).
IMPORTANT
If the sound of the motor changes to a high
pitch, this indicates the dirty water tank is full
and must be emptied.
noTe: For best cleaning results use a steady,
forward and backward motion. Cleaning should be
done at half the speed or less of dry vacuuming. For
heavily soiled areas, repeat if necessary.
CAUTION
!
Not to be used for grooming a pet.
above floor CleaninG/
attaCHMents
2.13 Put cleaner in its upright position. Connect the
upholstery attachment to the trigger adaptor.
2.14 Open the dirty water tank door and insert the
hose adaptor into the dirty water tank and turn
clockwise to lock in place.
2.15 Connect the base water supply connector into
the fitting on the lower left side of handle facing
cleaner.
All manuals and user guides at all-guides.com
2.10
2.12
!
2.13
2.15
8
2.11
A
CAUTION
!
Do not clean over floor electrical outlets.
IMPORTANT
Water will drip from the brushes and underside of
the product after use and may puddle. To
avoid damage to wood and laminate flooring
and to avoid potential slip hazard, after use (a)
do not leave the product on wood and laminate
surfaces (b) and place unit on absorbent
material (such as a towel) to soak up drips.
2.14
b
!