Work Area; Personal Safety - Milwaukee 6125 Manual Del Operador

GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below, may result in
electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS

WORK AREA

Keep your work area clean and
well lit.
Do not operate power tools in ex-
plosive atmospheres, such as in
the presence of flammable liq-
uids, gases, or dust.
Keep bystanders, children, and
visitors away while operating a
power tool.
ELECTRICAL SAFETY
Grounded tools must be plugged
into an outlet properly installed
and grounded in accordance with
all codes and ordinances. Never
remove the grounding prong or
modify the plug in any way. Do not
use any adaptor plugs. Check with
a qualified electrician if you are in
doubt as to whether the outlet is
properly grounded.
Double Insulated tools are
equipped with a polarized plug
(one blade is wider than the other).
This plug will fit in a polarized out-
let only one way. If the plug does
not fit fully in the outlet, reverse
the plug. If it still does not fit, con-
tact a qualified electrician to install
a polarized outlet. Do not change
the plug in any way.
Avoid body contact with grounded
surfaces such as pipes, radiators,
ranges and refrigerators.
Do not expose power tools to rain
or wet conditions.
Do not abuse the cord. Never use
the cord to carry the tools or pull
the plug from an outlet. Keep cord
away from heat, oil, sharp edges
or moving parts. Replace damaged
cords immediately.
When operating a power tool out-
side, use an outdoor extension
cord marked “W-A” or “W”.

PERSONAL SAFETY

. Stay alert, watch what you are do-
ing, and use common sense when
operating a power tool. Do not use
tool while tired or under the influ-
ence of drugs, alcohol, or medica-
tion.
Dress properly. Do not wear loose
clothing or jewelry. Contain long
hair. Keep your hair, clothing, and
gloves away from moving parts.
2
Avoid accidental starting. Be sure
switch is off before plugging in.
Remove adjusting keys or
wrenches before turning the tool
on.
Do not overreach. Keep proper
footing and balance at all times.
Use safety equipment. Always
wear eye protection.
TOOL USE AND CARE
Use clamps or other practical way
to secure and support the work-
piece to a stable platform.
Do not force tool. Use the correct
tool for your application.
Do not use tool if switch does not
turn it on or off.
Disconnect the plug from the
power source before making any
adjustments, changing accesso-
ries, or storing the tool.
Store idle tools out of reach of chil-
dren and other untrained persons.
Maintain tools with care. Keep cut-
ting tools sharp and clean.
Check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition that
may affect the tool’s operation. If
damaged, have the tool serviced
before using.
Use only accessories that are rec-
ommended by the manufacturer
for your model.
SERVICE
Tool service must be performed
only by qualified repair personnel.
When servicing a tool, use only
identical replacement parts.
Follow instructions in the Mainte-
nance section of this manual.
3