Thermal Protector; Check Bag Indicator - Titan T9200 Manual Del Usuario

To correct the problem: Turn off the vacuum cleaner, remove the obstruction, then turn on
the vacuum cleaner again. The brushroll status indicator will be off.
If the problem persists, have the vacuum cleaner serviced by a Titan Vacuums or other
qualified service agent.

THERMAL PROTECTOR

This vacuum cleaner has a thermal protector which automatically trips to protect the
vacuum cleaner from overheating. If a clog prevents the normal flow of air to the motor, the
thermal protector turns the motor off automatically. This allows the motor to cool in order to
prevent possible damage to the vacuum cleaner.
To correct problem: Turn off and unplug the vacuum cleaner to allow the vacuum cleaner to
cool and the thermal protector to reset. Check for and remove clogs, if necessary.
See REMOVING CLOGS (page 26). Also check and replace any clogged filters. Wait
approximately fifty (50) minutes and plug the vacuum cleaner in and turn back on to check
if the thermal protector has reset.

CHECK BAG INDICATOR

When the vacuum cleaner is running with normal airflow, the CHECK BAG light is off. The
light comes on whenever the bag is full, airflow becomes blocked, or if there is a clog. If
that occurs, first check the disposable dust bag. Then check the motor safety filter and
other possible clog locations shown in REMOVING CLOGS (page 26).
To correct problem: See the TROUBLESHOOTING table (page 43-45).
NOTE: The indicator light may come on when using certain attachments, due to reduced
airflow through attachment. When using in LOW POWER the indicator light may not
function.
CHECK BAG
Indicator
-25-