Titan T9200 Manual Del Usuario página 35

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13. Remove the middle cover. Carefully pull the PCB board and headlight board through
the middle cover. Then pull the two motor wires through the middle cover. Pay attention
to reserve the two felt washers properly for re-installation.
Felt
Washers
14. To remove the wood agitator, first remove its non-belt side. Lift the end cap up as
shown and release the non-belt side from the base.
15. Remove the belt side of the agitator. Use a suitable tool (e.g. a screwdriver) to carefully
pry off the end cap at position 1 as shown, and then release the belt side from the
base.
Motor Wires Wood Agitator
PCB Board
II
1
Headlight Board
I
-35-
Middle Cover

Publicidad

Tabla de contenido
loading

Tabla de contenido