Replacing Dust Bag - Titan T9200 Manual Del Usuario

5. Pull bag out of the bag mount and dispose of dust bag.
NOTE: Check the motor safety filter and replace, if necessary. (See MOTOR SAFETY
FILTER CHANGING, page 29).
NOTE: The bag mount will flip forward after removing bag. This will prevent the hood from
closing until a new bag is installed.

REPLACING DUST BAG

Note: DO NOT bend or crease the middle of the cardboard when installing the bag into the
bag mount slots.
1. Verify that vacuum cleaner is unplugged.
2. Rotate bag mount down and install bag into slots per illustration. Then push down until
the cardboard tab locks into position and the holes are aligned.
3. Tuck the bag securely into the bag cavity so that none of the bag is able to be pinched
by the hood.
4. Close and latch canister hood.
5. Insert hose into canister until it snaps in place. ASSEMBLY INSTRUCTIONS, page 9-12).
CAUTION
NEVER EMPTY OUT AND REUSE A DUST BAG.
Very fine materials, such as carpet freshener, face powder, fine dust, plaster, soot, new
carpet lint, etc. can clog the bag and cause it to burst before it is full and may cause
damage to vacuum cleaner motor. Change bag more often when vacuuming these
materials.
-28-