Daily Use - Washing & Drying - Zanussi ZWT 71401 WA Manual De Instrucciones

Drying setting
The recommended load size is 3 kg
for cottons and linen, and 2 kg for
synthetic items. You can also to dry
up to 4 kg of cotton items (see the
«Drying Programme » table).
WARNING!
Open the water tap. Put the
drain hose in the sink or
connect to the drain pipe.
1. Load the laundry one item at a time.
2. Turn the programme dial to the programme
applicable for the items to dry (cottons or
synthetics).
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of
the set programme.
Timed drying
1. Press the button Tiempo/Tempo de sec.
again and again to set the time value (see
the «Programmes for timed drying» table).
• Each time you press this button the time
value increases by 5 minutes.
• As the appliance calculates also the
duration of the anti-crease and the
cooling phases, the programme time will
automatically increase by some minutes.
2. Press Inicio/Pausa button to start the
programme.
Daily use - Washing & Drying
WARNING!
Refer to Safety chapters.
Non-Stop programme (Automatic
washing & drying)
For NON-STOP programme the recommended
load size is 3 kg for cotton and 2 kg for
synthetic.
CAUTION!
Do not use a dosing device/ball
when carrying out a washing
and drying programme.
1. Load the laundry one item at a time.
14
• The display shows regularly a new time
value.
• The indicator
If you set only 10 minutes of drying,
the appliance performs only a
cooling phase.
If the laundry is not sufficient dry, set again a
short drying time.
End of the drying programme
The appliance stops automatically.
• The acoustic signals operate (if they are
active).
• In the display comes on.
• The indicator of the Inicio/Pausa button goes
off.
• The last minutes of the drying cycle the
appliance performs a cooling and anti-
crease phase. The door is still locked. The
display show a flashing
When the door locked indicator
you can open the door.
1. Turn the programme knob to
deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
2. Put the detergent and the additives in the
appropriate compartment.
3. Turn the programme knob to the required
programme to switch the machine on.
4. Set the available options.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of
the set programme.
is on.
.
goes off,
position to
www.zanussi.com