Simpson Megashot MS61217 Guia De Inicio Rapido página 3

Assembly:
1.
Press and hold
buttons then slide
handle onto frame until
buttons click into place.
3.
Make sure the inlet screen is
clean, inside the pump inlet, and
has the convex side facing out.
6.
Insert the male QC plug on the spray gun
into the female QC connector on the high-
pressure hose.
7.
Turn on the
water supply, aim
the spray gun in a
safe direction, then
squeeze and hold
the trigger for at
least 30 seconds or
until the water runs
steady and all the air
is purged from the
pump and hoses.
Fill Engine With Oil:
1.
Place machine on a level surface then remove the engine oil dipstick by unscrewing it.
Engine Oil Dipstick
Page 3 of 4
OR
4.
Turn on the water supply and run it for 30
seconds to purge any dirt or debris from the supply
hose. Then, turn off the water supply and thread
the water supply hose into the pump inlet.
OR
This pressure washer was shipped from the
factory without oil in the engine. Running the
engine without oil will result in severe engine
damage and void the warranty. To avoid
causing engine damage and voiding the
warranty, fill the engine with the recommended
oil type before starting.
OR
Copyright 2021. All Rights Reserved.
Slide the handle onto
the frame then secure
it with the included
knobs and bolts.
5.
pressure hose into the female QC outlet on the pump or thread
the high-pressure hose onto the pump outlet.
Thread the high-pressure hose onto
the spray gun inlet.
8.
Select the correct
nozzle for
cleaning
nozzle selection chart
in this document and
install it onto the lance
by pulling the quick-
connect coupler back,
inserting the nozzle,
then releasing
coupler allowing it to
snap back in place.
Engine Oil Dipstick
Part Number 7117172 / English
2.
Thread the lance into the spray gun.
Insert the male quick-connect (QC) plug on the high-
OR
Thread the high-pressure hose onto
the spray gun inlet.
OR
9.
Remove fuel cap, fill fuel tank with fresh
gasoline, then replace fuel cap.
your
job per
NOTE: Fill with engine off and cool. Do not
over fill fuel tank.
the
2.
Fill the engine
with the correct
oil per the engine
owner's manual.
The oil level should
be towards the
high mark on the
dipstick. Replace
the dipstick when
the engine is full.
Upper Limit
Lower Limit
Full
Upper Limit
Lower Limit
OR
REV 1 - 10/18/2021