Simpson Megashot MS61217 Guia De Inicio Rapido página 4

Starting:
1.
Turn the engine
ignition switch and
the fuel valve to their
ON positions.
Using Chemicals:
1.
Attach the open
end of the soap hose
to the barbed fitting
on the pump.
NOTE: After using soap, place the filtered end of the soap hose into a container of clean water and run pressure washer drawing clean water through the
hose and pump until the system is thoroughly rinsed. If soap or other chemicals remain in the pump, the pump could be damaged. Pump damage from soap
or chemical residue is not covered under warranty.
Selecting a Nozzle:
Spray
Color
Pattern
Spot cleaning
hard, unpainted
Red 0° surfaces and
high-reach
Intense cleaning
Yellow 15° of unpainted
surfaces
Standard
cleaning
Green 25°
nozzle for most
applications
Cleaning painted
White 40° or delicate
surfaces
Applying
Black Soap cleaning
solutions
NOTE: Always make sure the nozzle is properly installed by tugging on it after
inserting it into the quick connector before using the pressure washer.
Page 4 of 4
2.
Adjust choke a needed.
CLOSED
NOTE: The starting position of the choke will vary
depending on the engine temperature. If starting
a cold engine, move the choke lever towards the
closed position. If starting a warm engine, move
the choke lever towards the open position. Once
the engine warms up from running, you may
need to adjust choke towards the open position
until idle is smooth.
2.
Place the
filtered end of
the soap hose
into a container
of soap or fill
the soap tank
NOTE: Use
only soaps that
are approved
for pressure
washer use.
Uses Surfaces
Unpainted metal and concrete
DO NOT use on wood
areas
Grills, driveways, concrete and
brick walkways, unpainted brick
and stucco
Yard tools, sidewalks,
furniture, unpainted siding, stucco,
gutters, eaves, concrete, and brick
surfaces
Autos, trucks, RVs, boats,wood,
painted brick, painted stucco, vinyl,
and painted siding
Safe on all surfaces. Always verify
compatibility of cleaning solutions
prior to use.
Copyright 2021. All Rights Reserved.
OPEN
SOAP
OR
Pressure Washing Tips:
1. A wider spray equals faster cleaning, while tighter spray equals
deeper cleaning.
2. Do not aim the nozzle straight at a surface. Hold the wand at a
45-degree angle to the surface and at a distance that cleans well
without causing damage.
lawn
3. Keep the nozzle about 4-feet away from siding to prevent damage
to surfaces.
4. Wash siding by starting at the bottom and working your way up,
then rinse from the top down.
5. Avoid driving water up behind siding.
6. For even cleaning, use overlapping strokes.
7. Work in smaller areas and do not let soap dry on surfaces.
Part Number 7117172 / English
3.
Pull the recoil slowly until resistance is
felt, then pull rapidly to start the engine.
3.
Insert the black
nozzle into the
spray wand.
NOTE: Soaps will
not siphon if the
black soap nozzle
is not installed on
the spray wand.
REV 1 - 10/18/2021