To Start The Product; To Prepare The Product For Start; About The Surface - Husqvarna 525PT5S Manual Del Usuario

• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than 1/3 of the branch
thickness to prevent jamming. Keep the chain
running while you withdraw the cutting attachment
from the branch to prevent it jamming.
• Use the harness to support the weight of the
machine and make it easier to handle.
• Make sure you have a firm footing and that you can
work without being hampered by branches, stones
and trees.
WARNING: Never activate the throttle
without having the cutting attachment in
full view.

To prepare the product for start

1. Press the air purge repeatedly until the fuel starts to
fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
14
WARNING: The saw chain will start to
rotate immediately when you start the
engine with the choke.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope
all the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.

About the surface

WARNING: Do not put parts of your body in
the grey marked area. If you touch the grey
marked area it can result in burns to the
skin. It can also cause electrical shock if the
spark plug cap has been damaged. Do not
use a product with a damaged spark plug
cap.
Safety on page 4 ).
712 - 002 -