About The Surface; To Start The Product; To Stop The Product - Husqvarna 525P4S Manual De Usuario

2. Move the choke control up into choke position.
WARNING:
to rotate immediately when you start the
engine with the choke.

To start the product

WARNING:
instructions in the safety chapter before you
start the product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION:
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING:
rope around your hand.
5. Pull the cord quickly and with power.
CAUTION:
rope all the way out and do not let go off
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
6. Pull the starter rope until the engine starts or for a
maximum of 5 times.
7. Reset the choke when the engine starts or after you
pull the starter rope 5 times.
703 - 008 - 02.11.2022
The saw chain will start
Read the warning
Safety on page 4 ).
Do not use your feet!
Do not twist the starter
Do not pull the starter
8. If it is necessary, pull the starter rope again and
again until the engine starts.
9. Let the engine run for 10 seconds.
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
Note:
If the engine stops, do the procedure again.

About the surface

WARNING:
body in the grey marked area. If you touch
the grey marked area it can result in burns
to the skin. It can also cause electrical shock
if the spark plug cap has been damaged.
Do not use a product with a damaged spark
plug cap.

To stop the product

1. Move the stop switch into the stop position to stop
the engine.
CAUTION:
automatically goes back to its initial
position. In order to prevent accidental
starting, the spark plug cap must
be removed from the spark plug
when assembling, checking and/or
maintenance is done.
Do not put parts of your
The stop switch
15