3M Speedglas G5-02 Instrucciones De Uso página 7

Date: 06/10/19
This artwork has been created as requested by 3M. 3M is responsible for the artwork
AS APPROVED and assumes full responsibility for its correctness.
tabs towards the outside of the helmet and slide the suspension forward, making sure to lock the sliding
mechanism in place (Fig. 1c).
Fig. 1a
3. An optional size large comfort head rest (46-0400-55) that will fit to the ratchet is available. This large
comfort head rest can also be used to improve fit and stability for smaller head sizes (Fig. 2).
4. The resting tilt of the welding helmet (how far downward the lens settles) and the distance from the face may
also be adjusted.
a. At the right-side pivot point there is a small lever to stop the downward travel of the welding helmet.
At the high position the welding helmet will come to rest so the welder can weld slightly above eye
level. At the low position the welding helmet will face at a slightly downward angle (Fig. 3a). With the
welding shield in the up position, push the lever in toward the head and adjust it up or down. Bring
the shield down to the stopping point to see where it rests.
b. To adjust the welding helmet in and out (closer and further from the face) there are two slides on
either side of the head suspension. To unlock the slides, push out on the blue buttons with your
thumbs and slide the welding helmet out or in, adjusting to your personal preference (Fig. 3b). This
adjustment will help with safety glasses spacing and also magnification lens distance.
Fig. 1b
1.
2.
3.
Fig. 2
5
Fig. 1c