Loading Nails; Nailer Operation - Hitachi Koki NT 65M2 Instrucciones Y Manual De Seguridad

Clavadora de acabado
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back.
Nail feeder
(2) Pull the nail feeder until the concave portion of the
magazine cover clicks.
Magazine cover
(3) 1 Insert nail strips one by one from above the
magazine.
2 Slide nails forward in the magazine.
2
(4) 1 While holding the nail feeder adjust the magazine
cover in place.
2 Slide the nail feeder slowly forward until it
contacts nails.
WARNING
Concave portion
Nail feeder
1
Magazine
Nail strips
)
2
NOTE
● Use nails at least 5 nails remaining.
● Slide the nail feeder SLOWLY forward.
If the nail feeder is released roughly, it may be stuck
between the magazine and nails, which makes mis-
feeding trouble.

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 7).
● NEVER point tool at yourself or others in
work area.
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental fi ring.
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Before starting work, check the nailing
operation switching device.
This Hitachi nailer includes a nailing
operation switching device.
English
Magazine cover
Nail feeder
2
1
DANGER
● Operators and others in work
area MUST wear safety
glasses with side shields
which conforms to ANSI
Z87.1 specifi cations.
WARNING
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nt 65m2 s

Tabla de contenido