Qlogic QME8242 Guia Del Usuario página 120

iBFT Boot Setup: QLogic QME8242 Mezzanine Card User's Guide
7. Press the <Esc> key to return to the Adapter Settings menu.
8. On the Adapter Settings menu, select Primary Target Settings and then press <Enter>.
9. Under Target Settings, configure the following, as shown in
a. Set the Target Name, Target IP Address, Target Port, and Boot LUN to the appropriate settings for the target
setup.
b. (Optional) Specify the CHAP Type as one of the following:
None to disable CHAP
One-Way for a target-authenticating initiator
Mutual to enable both the target and initiator to authenticate each other
c. (Optional) Configure the Target CHAP Name and Target CHAP Secret as needed.
Figure 10. Configuring Target Settings for IPv6 (Static)
10. Press the <Esc> key and save the settings.
11. Reboot the system.
Setting Up a Dynamic IPv6 Address
file:///T|/htdocs/NETWORK/QLogic/71922/en/ibft.htm[9/26/2012 4:26:32 PM]
All manuals and user guides at all-guides.com
Figure 10: