1- Product characteristics:
with integrated limit switches for a maximum of 600W. The control unit enables:
-
selecting awning or rolling shutter operation
-
separate inputs for opening and closing
-
inputs for the wind, rain and sun sensor
-
LED for sensor diagnostics
-
integrated receiver at 433.92 MHz with capacity for 100 remote controls with 2 channels (hard coded or rolling code)
Technical characteristics:
Back box dimensions
Protection rating
Power supply
Sensor power supply
Consumption in standby
230V fuse
Relay contacts
230V motor output
Opening and closing input buttons
Safety input on closing (shutters and rolling shutters) 1 input for N.C. contacts
SUN sensor input (awnings)
WIND sensor input (awnings)
RAIN sensor input (awnings)
Remote Controller
Remote controller encoding and working frequency
Operating temperature
2- Description of the control unit:
1
Key:
1-
Terminal for mains connection and electric motor power supply
2-
Electric motor control relay
3-
Connector for additional modules
4-
DIP switch selecting operation (rolling shutters, awnings or manned)
5-
Remote controls learning button
6-
Terminal for connecting sensors and control buttons
7-
Fuse protecting electric motor ( 3.15 A )
8-
Switching power supply unit
9-
Radio module
10-
Two-colour LED for wind and light sensor diagnostics
11-
LED for fault diagnosis of rain sensor and presence of mains power supply
12-
Trimmer for adjusting the wind sensor trip threshold
EN
All manuals and user guides at all-guides.com
control unit for awnings or rolling shutters, selectable via DIP switch. This device can control electric motors at 230Vac
156x62x30h mm
IP44
115/230VAC 50/60Hz
12VDC 300mA max
0.6W
5AF 5x20 mm
10A 230VAC
230VAC 600W maximum
2 inputs for N.O. push-buttons
1 analogue input 4..20mA
1 input not powered for reed contacts
1 analogue input 4..20mA
Up to 100 remote controllers with 2 buttons
Rolling Code and hard coded 12-bit 433MHz AM
-20/+60°C
7
RELAy 1
RELAy 2
2
8
10
11
12
3
4
9
6
5
15