Festo 8097522 Instructions De Service página 42

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MPS
Industry 4.0 upgrade kit
®
Pneumatic safety
Depressurize the system.
Switch off the compressed air supply before working on the circuit.
Check the system using pressure gauges to make sure that the entire circuit is fully depressurized.
Please note that energy may be stored in reservoirs.
Further information on this issue is available in the data sheets and operating instructions
included with the components.
Do not exceed the maximum permissible pressure of 600 kPa (6 bar).
Do not switch compressed air on until all barbed tubing connections have been established and
secured.
Do not disconnect tubing while under pressure.
Do not attempt to connect tubing or push-in connectors with your hands or fingers.
Risk of injury when switching compressed air on.
Cylinders may advance and retract automatically.
Risk of accident due to advancing cylinders.
Always position pneumatic cylinders so that the piston rod's working space is unobstructed over
the entire stroke range.
Make sure that the piston rod can't collide with any rigid components of the setup.
Risk of accident due to tubing flying off.
Use shortest possible tubing connections.
In the event that tubing flies off:
Switch off the compressed air supply immediately.
Pneumatic circuit setup:
Connect the devices with plastic tubing with an outside diameter of 4 or 6 mm. Push the tubing into the
push-in connector as far as it will go.
Switch off the compressed air supply before dismantling the circuit.
Dismantling the pneumatic circuit
Press the blue release ring down so that the tubing can be pulled out.
Noise due to escaping compressed air
Noise caused by escaping compressed air may damage your hearing. Reduce noise by using
silencers, or wear hearing protection if noise can't be avoided.
All of the exhaust ports for the components included in the equipment set are equipped with
silencers.
Do not remove these silencers.
42
© Festo Didactic 8097301

Publicidad

Tabla de contenido
loading

Tabla de contenido