The Joining Station Industry 4.0 - Festo 8097522 Instructions De Service

8.3 The joining station Industry 4.0

The joining station consists of a separating station which has been expanded with a pick & place module
and a bus node. The pick & place module is equipped with a suction cup for joining the workpiece caps and
the MPS workpiece bases.
®
The station can remove workpiece bases from, or place them into the flow of materials. The workpiece base
is held in the joining position at the deflector.
The function of the station is to:
•
Remove workpieces from the flow of materials
•
Place workpieces into the flow of materials
•
Mount workpiece caps on the MPS
Note:
Microcontroller workpiece caps can be mounted on the MPS
This requires mounting kit 8064882 in order to switch over from a suction cup to a parallel gripper
with gripper jaws.
© Festo Didactic 8097301
workpiece bases
®
workpiece bases with the station.
®
MPS System 203 Industry 4.0
®
53