Installation; I.1 Positioning, Configurations And Accessories - Graco 127642 Manual De Instrucciones

I

INSTALLATION

NOTICE
PRELIMINARY - Verify that all components are present. Request any missing parts
from the manufacturer.
INSPECTION
- Check that the pump has not suffered any damage during trans-
port or storage.
- Carefully clean the suction and delivery inlets and outlets, remov-
ing any dust or other packaging material that may be present.
- Check that the electrical data corresponds to those indicated on
the data plate.
- Always install in an illuminated area.
- Install the pump at a height of min. 80 cm.
I.1 POSITIONING, CONFIGURATIONS AND ACCESSORIES
WARNING
WARNING
NOTICE
NOTICE
NOTE
NOTICE
M0307
The pump must never be operated before the delivery
and suction lines have been connected.
FIRE AND EXPLOSION HAZARD
The motors are not of the anti-explosive-type.
do not install them where inflammable vapours could
be present.
EQUIPMENT MISUSE HAZARD
It is the responsibility of the installer to provide the
necessary line accessories to ensure the correct and
safe operation of the pump. The accessories that are
not suitable to be used with the previously indicated
material could damage the pump and/or cause
injury to persons, as well as causing pollution.
In the case of installation in the open air, proceed to
protect the pump by providing a protection roof.
The pump can be installed in any position (pump axis
vertical or horizontal)
The pump must be secured in a stable way using the
holes on the bed of the motor and vibration damping
devices.
The broad range of pump accessories make it suit-
able for many different uses, installations and ap-
plications. The supporting base can be positioned in
different ways.
The pump can be installed in any position (pump axis
vertical or horizontal)
To maximise performance and prevent damage
that could affect pump operation, always de-
mand original accessories.
EN
9