Device Mounting And Connection; Water Supply Connections - TESY HPWH 2.1 260 U02 S Instrucciones De Uso Y Mantenimiento

Fig. 6a - Example of installation in summer

5.4. Device mounting and connection

The device must be installed on a stable, flat floor surface that is not subject to vibration.
Dimensions [±5mm]
h [mm]
a [mm]
b [mm]
d [mm]
f [mm]
i [mm]
k [mm]
n [mm]
u [mm]
w [mm]
R [mm]
ØD [mm]
ØDF [mm]
M [mm]
* - for models with heat exchanger only!
The table below shows the characteristics of the connection
points.
CW - cold water inlet - G1"
HW - hot water outlet - G1"
IS - solar flow - G1"
OS - solar return - G1"
TS - thermosensor - G 1/2"
R - recirculation - G 3/4"
EE - opening for electrical element - G 11/2
MA - Mg anodes - G11/4
CD – condense drainage – G3/4

5.5. Water supply connections

The following illustration (Fig. 8) shows an example of a water supply connection.
260 200
2010 1720
1285 994
834 724
1285 995
1064 803
781* 681*
60 60
766* 681*
1440 1153
58 58
2055 1785
630 630
160 160
260 260
Fig. 6b Example of installation in winter
Fig. 7 – Overall dimensions
14