Oster FPSTJE4000R Manual De Instrucciones página 22

P RESS J U I CE R A S S EMBLY IN D ETA IL
Step 1.
Firmly insert the extraction seal located at the bottom of the chamber into the
pulp outlet. Make sure the outer groove of the chamber is completely aligned
with the base ridge. Then turn the chamber clockwise to secure it to the base.
Steps 2,3.
Assemble the parts in the following order: chamber (1) > spinning brush (2) >
strainer (3) > auger (4) > hopper (5). (Or assemble the spinning brush into the
chamber. then fit the strainer projection into the chamber inner groove). Make sure
the arrow
Hopper(5)
Auger(4)
Strainer(3)
Spinning
Brush(2)
Chamber(1)
Step 4.
Make sure the lock symbol [
mark on the top of the base.
Extraction
seal
[ ]
of the strainer aligns with the arrow
Base ridge
Chamber outer groove
[ ]
Strainer
Base [ ]
] on the hopper is aligned with the arrow [
En g lish -5
[ ]
at the top of the base.
]