1.
Assemble the parts in the following order:
chamber (1) > frozen treat attachment (2) > auger
(3) > hopper (4). Make sure all the arrows
are aligned.
2. Press on button "I" to start.
3. Cut frozen fruits and/or other incredients them into
small pieces, less than 5 cm in length, that will fit
in the hopper chute. Place pieces in hopper chute
and slowly press them down with pusher.
4. Once completed, click reverse " " to stop. Motor
does not stop immediately upon pressing reverse
" ". For safety reasons and to preserve the
performance level of the appliance, the motor will
slowly come to a complete stop.
5. Stir frozen treat for an ice cream like consistency.
WHE N T HE AUG ER I S STOPPE D DURING
OP ER AT IO N R EVE RS E "
1.
Click the reverse " " button on the operating switch and stop
the appliance.
Hold down the reverse " " button on the operating switch for
3~5 seconds and release it. Repeat this process 2~3 times. The
reverse " " button pushes the ingredients back up. Reverse only
works while the button is held down. The reverse rotation of the
auger stops once the button is released.
2.
After the rotation stops completely, press the on "I" button to
operate. Before changing the rotation direction of the auger, make sure
that the auger has come to a complete stop.
NOTE: If the auger does not work even after following the directions
above, unplug the power cord, and disassemble and clean the
chamber, the filter and the auger before reuse.
M A KI NG F R OZ EN TREATS
En g lish-8
Hopper (4)
Auger (3)
Frozen treat
attachment (2)
Chamber (1)
" B UTTON
Stop
Reverse
direction
" "
Normal
direction
(I)