Oster FPSTJE4000R Manual De Instrucciones página 30

ASSEMBLING THE SPINNING BRUSH
1.
Check the groove of the spinning brush and the direction of the silicone brush.
There are grooves in which to insert the silicone brush into the spinning brush. The silicone
brush has an inner wing (1) and an outer wing (2).
As shown in the figure on the left, position the silicone brush so that the 'inner wing 1' faces
the spinning brush.
2.
Insert the silicone brush into the spinning brush.
Hold the wing so that the longer part of inner wing (1) faces upward (see Step 1 above).
Hold the outer wing (2) of the silicone brush with your thumb and index finger and insert the
inner wing into the groove of the spinning brush.
3.
Pull the inner wing tightly into the spinning brush.
Push the silicone brush in from the outside and pull the inner wing into the spinning brush
with the other hand. (See figure.)
Pull the silicone brush tightly into the groove on the spinning brush. The unit may be
damaged if it is operated without being properly and fully assembled.
Make sure the silicone brush is placed firmly into the groove by holding the top and bottom
part of the outer wing and pulling it up and down in opposite directions.
SPINNING BRUSH
Inner
wing
SPINNING BRUSH SILICONE BRUSH
Inner
wing (1)
Brush
groove
SPINNING BRUSH
Inner
wing
En glis h-13
SILICONE BRUSH
(1)
Top
(longer)
Outer
wing
(2)
Brush
groove
Bottom
(shorter)
Top
(longer)
1
Outer
wing (2)
SILICONE BRUSH
Bottom
(1) 2
(shorter)
Top
(longer)
1
Outer
wing
(2)
Brush
groove
Bottom
2
(shorter)
1
2