Publicidad
Idiomas disponibles
Idiomas disponibles
The throttle cable (5) and electrical cables (5) are coupled
to the control handle. To connect them to the throttle
trigger and engine, use the following procedure:
1. Loosen the retaining bolt and remove the air filter cover
(13);
2. Insert the end of the throttle cable into the hole in the
retaining bolt. The end must be fully inserted into the
bolt groove;
3. Connect the electric cables of the control handle (6) to
the electric cables of the engine;
4. Fit and tighten the air filter cover.
The guard avoids the projection of loose objects and
accidental contact of the blade or nylon line with the user.
1. Adjust the clamping plate on the cutting attachment
bracket (2), place the bolt and nut;
2. Loosen the fixing bolts of the cutting attachment guard
(18);
3. Align the clamping plate holes and the guard holes on
the fixing bracket (17);
4. Place and tighten the bolts of the plate and guard;
5. Fit the flap to the guard's base and fix it to the slots.
The guard does not protect the user against all
objects (stones, glass, wire, etc) that fly off from the
cutting attachment. These objects can bounce off and hit
the user.
Check the blade condition before installing it to the
appliance. If it is damaged (cracked, bent or broken),
replace it.
1. Place the thrust plate over the rotation bolt (2);
2. Insert a hexagonal key or screwdriver into the hole in the
thrust plate and the hole in the cutting attachment
holder to lock the bolt (2);
3. Place the blade (1) over the thrust plate. Check that the
blade is placed with the cutting edge in the direction of
rotation;
4. Place the support cup and the blade's fixing nut on the
bolt. Tighten the nut counter-clockwise with the key
provided;
5. Remove the key.
1. Place the thrust plate on the rotation bolt (2);
2. Insert a hexagonal key or screwdriver into the hole in the
thrust plate and the hole in the cutting attachment
holder to lock the bolt;
3. Tighten the mowing head with nylon line into the thread
of the rotation bolt counter-clockwise;
4. Remove the key.
1. Press the locking tabs and remove the support cup;
2. Remove the reel from the cover and remove the existing
line;
3. Prepare about 5m of nylon line and fold it in half.
4. Fix the line to the slot of the central spacer of the reel;
5. Wind the two ends in parallel, one on each side of the
central spacer, clockwise (arrow shown on the reel);
6. Attach the ends of the line to the outer fixing slots of the
reel;
7. Insert the reel into the mowing head cover;
8. Release the line from the fixing slots and insert the ends
of the line into the slots of the cover;
9. Place the support cup.
Publicidad
