Publicidad
Idiomas disponibles
Idiomas disponibles
Always use the shoulder harness strap when operating the
brush cutter.
1. Attach the shoulder harness strap hook to the brush
cutter's clip;
2. Adjust the strap so that the left hand can comfortably
hold the handles at approximately waist height;
3. Make sure shoulder strap is properly attached.
When using the brush cutter, you should take into
consideration some precautions and use procedures to
avoid accidents, damage and increase the performance
and efficiency of the equipment:
▪ Ensure that you start the brush cutter at a distance of
more than 3m from the fuelling point;
▪ Always hold the brush cutter on your right side with both
hands;
▪ Keep the cutting attachments below waist level, thus
reducing the risk of being hit during operation;
▪ Do not use the appliance to cut branches or logs. If you
try to cut logs above the recommended size, kickback
can occur and cause accidents to the user;
▪ When the brush cutter is running at idle speed, the
cutting attachment is not rotating. If not, contact service
center to carry out an inspection and solve the problem;
▪ If you hear an unusual noise or the brush cutter vibrates
abnormally, stop working and identify the cause;
▪ Never use the brush cutter if the guard is not installed or
if it is damaged.
1. Set the CHOKE lever to closed position. Pull the choke
lever all the way up. If the engine is warm or the air
temperature is high, do not set the CHOKE lever to closed
position;
2. Press the carburettor primer bulb several times until it is
filled with petrol. Check that the fuel line is full, then the
carburettor is full of fuel;
3. Turn the ON/OFF switch (8) to the "I" position;
4. Press the safety lever (9) and throttle trigger (7)
simultaneously. Press the throttle trigger lock button
(10) to lock the throttle;
5. Hold the brush cutter with one hand and pull the recoil
starter. Pull it slowly until you feel some resistance, then
pull strongly until the engine starts;
6. After starting the engine, the brush cutter runs at a mid-
speed between idle and full speed. If you want to start
the engine at idle speed, press and release the throttle
trigger;
7. A few seconds after starting, set the CHOKE lever to open
position. Move the CHOKE lever all the way down.
When the recoil starter returns to its original position,
your hand and arm can be drawn quickly towards the
combustion engine.
Let the engine running idle for a few seconds before
operating the brush cutter.
1. Release the throttle trigger (7) and set the "ON/OFF"
switch to (8) the "0" position;
2. If the throttle trigger is locked through the button, press
and release the throttle trigger. Set the "ON/OFF" switch
to position "0".
In case of imminent danger or emergency, stop the engine
immediately. Turn the ON/OFF switch to the "0" position.
Publicidad
