Publicidad
Idiomas disponibles
Idiomas disponibles
The mowing head with nylon line is used for cutting grass,
weeds or lawn.
Make sure that the nylon line is still firm and evenly rolled-
up in the reel; otherwise, the brush cutter will produce
harmful vibrations.
Only use mowing heads and nylon lines that have the
characteristics and dimensions recommended by the
manufacturer.
Never use wires or ropes instead of nylon line.
Otherwise, accidents and injuries may occur.
The length of the nylon line is also important. A longer line
requires more engine power than a shorter line with the
same diameter.
Make sure that the nylon line cutting knife inside of the
guard is still intact and sharpened. The knife will cut the
nylon line to the correct length.
When the nylon line is worn out or cracks:
1. Touch the mowing head to the floor and press gently the
spring in the inside to allow the nylon line to slide out;
2. The length of the cutting nylon line is defined by the
maximum length allowed for the blade.
The engine should run on a mixture of 95 unleaded petrol
and 2-stroke engine oil in the ratio of 1:40 (1L of two-stroke
engine oil for every 40L of petrol).
1. Pour the 2-stroke engine oil in a fuel mixing bottle;
2. Add petrol to 2-stroke engine oil;
3. Place the mixing bottle cap and shake carefully to mix
the oil with petrol.
Unsuitable fuels or with a different ratio than recommended
may lead to irreversible damage to the engine. Low-quality
petrol or oil can damage the engine, gaskets, hoses and the
fuel tank.
Keep the fuel mixture in proper and adequate containers in
a safe, dry, cool place protected from sunlight. Fuel mix
gets old, mix only the amount needed for a few weeks. Do
not store or use fuel with more than 30 days.
Shake the fuel mixing bottle before refuelling.
Pressure may form inside the tank, for this reason it
shall be opened carefully. Avoid direct skin contact
and inhalation of flammable vapours.
When refilling the fuel tank, do not add petrol above the
maximum level of the filler cap.
Before any maintenance or cleaning work, lay the
brush cutter down on a level surface, switch off the
engine and remove the spark plug cap from the spark plug.
Never touch the exhaust, spark plug, or other metal
parts of the engine while the engine is running or
immediately after turning off the engine. Doing so can lead
to severe burns or electric shock.
Publicidad
