Transportation, Storage And Disposal; Technical Data - McCulloch SUPERLITE 4528 Manual Del Usuario

The engine starts but stops again
Problem
Air filter
Blade
Problem
The blade moves slowly or
does not move.
The blade does not cut
easily.
The blade becomes hot.
Transportation and storage
• Always allow the product to cool down before
storage.
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel before transportation or before long-
term storage. Discard the fuel at an applicable
disposal location.
• Attach the transport guard during transportation and
storage.

Technical data

Technical data
Engine
Cylinder displacement, cm
Idle speed, rpm
Recommended max speed, rpm
Maximum engine power acc. to ISO 8893, kW/rpm
14
Possible cause
Clogged air filter.
Possible causes
The blade is blocked or it is
damaged.
The blade is not sharp or it
is damaged.
There is friction between
the blades.

Transportation, storage and disposal

Technical data
3
Recommended step
Clean the air filter.
Recommended step
Clean the blades from unwanted materials. Refer to
clean and lubricate the blades on page 12 . Remove
burrs from the blade, refer to
page 12 . Replace the blade if it is damaged.
Sharpen the blade, refer to
page 12 . Replace the blade if it is damaged.
Remove burrs from the blade and lubricate the blade.
To examine the blades on page 12 .
Refer to
• Remove the spark plug cap from the spark plug.
• Attach the product during transportation. Make sure
that it cannot move.
• Clean and do servicing on the product before long-
term storage.
Disposal
• Obey the local requirements and applicable
regulations.
• Discard all chemicals, for example engine oil or
fuel, at a service center or at an applicable disposal
location.
• Discard the product at an approved disposal location
or send it to McCULLOCH for disposal.
SUPERLITE 4528
21.7
2800
9000
0.6/7800
To examine the blades on
To examine the blades on
ERGOLITE 6028
21.7
2800
9000
0.6/7800
1255 - 003 - 10.03.2022
To