Dab-Radio - auna TT-186 DAB Manual De Instrucciones

3. Press Menu/Info button (3) again to return to the radio station. Perform
the auto tuning operation again as above.
FM-Stereo reception
During FM mode, press the Select button (9) repeatedly, the FM programs
are receiving in mono and auto mode (Stereo/Mono) repeatedly. In
particular when stereo signals are weak, it is preferable to receive the
program in Mono.
Radio data system (RDS)
This is the feature to display the information which released from the
radio broadcast and will showed on LCD display step by step as below by
pressing the Menu/Info button (3) button continuously.
Radio text > program type > signal strength > date > time > frequency >
mono/stereo

DAB-RADIO

1. After turning on the unit, set the unit to DAB mode by pressing the
Function button (2).
2. Press the Scan (4) button once, unit will start to full scan from range
11b-12d one time within around 2 second. Then press Skip up / down
button (7) button to select your desired DAB channel.
3. Press the Menu/Info button (3) continuously to check the below info
released by DAB.
scrolling text > program type > Group name > signal strength > date >
time > frequency > transfer rate.
4. Adjust the Power ON-OFF/ Volume Control Knob (15) to desired volume
level.
Preset stations
You can store up to total of 20 radio stations in the memory (10-FM/10-DAB).
1. Set to FM/DAB mode
2. Turn to the desired radio station by " manual " or " auto " tuning method.
3. Press and hold the Pre / Memory button (5) around two second to
enable memory state, the preset station will flash on LCD display.
4. Preset the Skip up / down button (7) button to select the desired
station memory for storage.
5. Press Select button (9) to confirm the preset memory.
6. Repeat step 2 to 5 to store other stations.
EN
25