Worx WG717E Traducción De Las Instrucciones Originales página 13

BLADE (13) MAINTENANCE (See Fig.
I1, I2)
WARNING! Never carry out any
assembly operations or adjustments
with the power connected to the mower.
Always ensure that the power button is in
the off position and that the power plug is
disconnected from the supply.
Always handle the blade with care-sharp
edges could cause injury use gloves.
Follow these procedures to remove and
replace the blade. You will need garden gloves
(not provided) and a spanner wrench to
remove the blade. Hold the Blade and unscrew
the Blade Bolt (12) anticlockwise using a
spanner wrench. Remove Blade and attach a
new one to the blade bolt.
Ensure that the blade is properly positioned as
seen in Fig. I1, then firmly tighten the bolt. DO
NOT OVER TIGHTEN.
Renew your metal blade after 50hrs mowing
or 2 years, whichever is the sooner-regardless
of condition.
If the blade is cracked or damaged
replace it with a new one.
TROUBLE SHOOTING
Symptom
Machine fails to operate
Machine functions
intermittently
Machine leaves ragged
Finish or motor labours
Cutting blade not
rotating while machine
switched on
Excessive vibration/noise Blade nut/bolt loose
Cordless Lawn Mower
All manuals and user guides at all-guides.com
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Mower in long grass
Extension cable damaged
Machines internal wiring
damaged
Height of cut too low
Cutting blade blunt
Underside of machine badly
clogged
Blade fitted upside down
Cutting blade obstructed
Blade nut/bolt loose
Cutting blade damaged
STORAGE: (See Fig. J)
Stop the mower and unplug the tool.
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and
debris, especially from the ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, release the handle cam lever,
and rotate or fold the upper handle.
You could carry the mover by Carry Handle
(10).
Ensure cables are not stuck or entangled when
folding or unfolding upper handles. Do not
drop the handles.
Turn power on
Use another socket
Inspect cable, replace if
damaged
Increase height of cut and tilt
mower
Inspect cable, replace if
damaged
Contact Service Agent
Increase height of cut (see "
adjusting the cutting height ")
Replace blade
(see "Blade Maintenance")
Clean machine
(see "Storage")
Refit blade correctly
(see "Blade Maintenance")
Clear obstruction
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace blade
Remedy
EN
13