Troubleshooting - Kenmore Lift-Up DU5092 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Review this table to find do-it-yourself solutions for minor performance problems. Any
service needed, other than maintenance described in this Use & Care Guide, should be
performed by a qualified service agent.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury.
PROBLEM
Unplugged at wall outlet.
The On/Off switch is not pressed
to start the vacuum cleaner.
Vacuum cleaner
Defective wall outlet.
won't run.
The vacuum body is overheated.
The motor is damaged.
The hose and attachments are not
installed correctly.
Dust cup is not installed correctly.
Full or clogged dust cup.
There is a clog in the flexible hose
or connection hose of the vacuum
cleaner.
Suction control is in open position.
Poor job of dirt
pick-up.
The foam filter, felt filter or HEPA
media exhaust filter needs to be
cleaned or replaced.
The hose is worn.
The connection hose is worn.
The brushroll is worn.

TROUBLESHOOTING

POSSIBLE CAUSE
Plug in firmly, press the On/Off switch to "I"
or "II" position.
Press the On/Off switch to "I" or "II" position.
Check with a good appliance or lamp. Have
outlet properly serviced.
Unplug the power cord and let the vacuum
cool down for 50 minutes.
Call 1-877-531-7321 (US) / 1-844-608-3081
(CA) for assistance.
Check the hose and attachments for correct
installation and ensure they are snapped
firmly in place.
Check dust cup for correct installation and
ensure it is snapped firmly in place.
Empty the dust cup (page 18).
Check and remove all clogs. Follow instructions
on page 22-23.
Adjust the suction control to increase suction.
Follow instructions on page 16.
Clean or replace the foam filter, felt filter or
HEPA media exhaust filter. Follow the foam
filter and felt filter cleaning or HEPA media
exhaust filter cleaning instructions on page 20
or 21.
Replace the hose assembly. To purchase parts,
call 1-877-531-7321 (US) / 1-844-608-3081
(CA).
Call 1-877-531-7321 (US) / 1-844-608-3081
(CA) for assistance.
Call 1-877-531-7321 (US) / 1-844-608-3081
(CA) for assistance.
- 24 -
SOLUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido