brennenstuhl WS 2050 S Manual De Instrucciones página 8

Operating Instructions
INSTALLATION AND CONNECTION TO POWER SUPPLY
1. Always switch off the power supply before installation.
2. The spotlight must be mounted at a height of less than 3 m.
Recommended mounting height for models with motion detectors is 2.5 m.
3. To fix the mounting plate to the wall, follow the steps (fig. 2 – 4).
4. Open the sleeve of the connection plug on the back of the light (fig. 1).
5. Feed the connecting cable through the sealed plug sleeve and connect the strands to the
luster terminal of the input plug (fig. 5).
6. Connect the spotlight to the mounting plate and tighten the screw (fig. 6).
7. Align the spotlight head.
8. Switch on the power supply again.
ADJUSTING THE SPOTLIGHT WITH MOTION DETECTOR (PIR)
The motion detector has a built-in sensor that can distinguish between daylight and darkness.
The ( ) position indicates that the connected light is switched on by the motion detector

during the day and night.
The (  ) position indicates that the connected luminaire is only switched on by the motion
detector during the night. You can set the desired light intensity at which the light is to be
switched on using the SENS rotary knob.
SETTING THE LIGHT DURATION
The light duration is the time period for which the motion detector leaves the light on after it
has been activated. The lighting time can be set from approx. 10 seconds to approx. 4 minutes.
Turning the TIME knob from (+) to (-) reduces the light duration.
Attention: Each time a movement is detected, this period starts again from the beginning.
SCOPE OF DELIVERY
LED-spotlight, operating instructions, screws, dowels, washers, mounting plate, clamp.
MAINTENANCE
CLEANING
Before cleaning, disconnect the floodlight from the mains power.
Do not use solvents, caustic cleaning agents or similar products.
Only use a dry or slightly moistened cloth for cleaning.
8 8
21P018 Mobiler LED Strahler WS 220217.indd 8 21P018 Mobiler LED Strahler WS 220217.indd 8
WS 2050 X, WS 2050 XX
ATTENTION: The LED lamp does not contain
components that require maintenance.
The light source in this lamp cannot be replaced;
if the light source has reached the end of its
service life, the entire lamp has to be replaced.
The lamp may not be opened.
17.02.2022 11:53:24 17.02.2022 11:53:24