Connect Crp Temperature Sensor Calibration; Technician Menu - System Type; Technician Menu - Digital Input - Ferroli Connect CRP Manual De Instalacion Y Uso

6.2.1

CONNECT CRP TEmPERATURE SENSOR CALIBRATION

The Connect CRP allows the detected room temperature to be corrected by entering an offset between -6 °C and
+6 °C,
in steps of 0.1°C.
The default value is set to 0.0°C.
1. Access the "TECHNICAL" menu (see "6.1 Accessing the TECHNICAL menu" on page 101)
2. Follow the path "MENU >> TECHNICAL >> INSTALLATION >> SENSOR CALIBRATION"
3. Use the and
tected by the Connect CRPwill be shown above the offset value .
button to confirm the entered value
4. Press the
6.3

TECHNICIAN mENU - SYSTEm TYPE

Using the and
TYPE menu and confirm with the
From this menu it is possible to set the type of system that the Connect CRP will manage. The available settings are:
FULL ELECTRIC
Monobloc or split heat pump, with or without stor-
age tank and without the aid of a boiler as sup-
port
HYBRID H
Hybrid system for room heating/cooling and
DHW production, consisting of heat pump and
boiler as support, with or without storage tank
6.4

TECHNICIAN mENU - DIGITAL INPUT

Using the and
menu and confirm with the
From this menu it is possible to enable and disable the
"Digital inputs" function.
NOTE For correct configuration, the system config-
uration must be scrupulously followed.
buttons to change the offset of the detected temperature: the new temperature value de-
buttons, select the SYSTEM
button .
buttons, select the "Digital inputs"
button.
cod. 3542B380 - Rev 00 - 05/2022
T E C H N I C A L
I N S T A L L A T I O N
S Y S T E M T Y P E
D I G I T A L I N P U T
I N S T A L L E R
fig. 67
HYBRID C
Hybrid system for room heating/cooling, consist-
ing of heat pump and instantaneous boiler as
support. DHW production is only with boiler.
NOTE
For correct system setup, refer to the unit model.
T E C H N I C A L
I N S T A L L A T I O N
S Y S T E M T Y P E
D I G I T A L I N P U T
I N S T A L L E R
fig. 68
103
EN