Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. CUSTOM HOOD PREPARATION (
To minimize the gap around the power pack, take actual width and depth measurements
of power pack and add 1/16" to get D and E measurements. Cut the hole in the bottom
of the cabinet according to dimensions. See chart and illustration for details.
P
P
OWER
ACK
M
ODEL
CP34
CP35
AND
CP37
4. MOUNT CUSTOM HOOD INTERNAL FRAMEWORK
The framework must be positively secured to wall studs or other wooden framework behind the drywall. Make sure
it is capable of supporting its own weight and the weight of the CP34, CP35 or CP37. Failure to do so may cause
personal injury or damage to countertop or cooktop.
The CP34, CP35 and CP37 power pack models are supported by the custom hood
internal framework with screws provided in parts bag.
Since the CP34, CP35 and CP37 power pack models mounting holes are located in
front and rear sides (see illustration at right), plan to install wood frame at front and
sides for support.
5. REMOVE FILTERS
Remove tape on filters. Remove filters from power pack and set aside.
NOTE: It is recommended to start with the center one(s).
CONT
C
UTOUT
W
DIMENSIONS
IDTH
D
E
30"
19
3
⁄
"
28½"
8
3
36"
19
⁄
"
34½"
8
3
42"
19
⁄
"
40½"
8
48"
22
5
⁄
"
46½"
8
'
)
D
WARNING
!
5
E
HD0367
HH0102A
HD0295
D
Publicidad
Tabla de contenido
