Best CP34 Serie Instrucciones De Instalación página 6

6. REMOVE GREASE DRIP RAIL
A. Lift grease drip rail to disengage it from the bottom
panel.
B. Slide grease rail all the way to the left or right () and
lift the opposite end to disengage the other end from
the bottom panel (). Remove it from the power pack
and set aside for later use.
7. REMOVE BOTTOM PANEL
Using a Phillips screwdriver, remove both bottom panel retaining
screws and set aside.
R
ETAINING SCREW LOCATIONS
HO0110
8. REMOVE KNOCK-OUT OPENING
From inside the power pack, remove the wiring cover by removing 2 retaining screws and set
aside. Punch out the electrical knockout hole on top of the power pack. Install the wire clamp
(included in parts bag).
9. INSTALL ADAPTER/DAMPER (CP34 AND CP35 MODELS)
Using 4 no. 8 x 3/8" screws from parts bag, assemble the adapter/damper on the top of the power
pack. To ensure proper opening of the dampers, remove shipping tape if present. Seal all joints
with metal foil duct tape to eliminate air leaks.
A
HD0291
Disassemble bottom panel from power pack and set aside.
6
B


HD0292
S
HO0111 IDE VIEW
HR0027
M
OUNTING SCREW
HJ0016
LOCATIONS