Cleaning The Hot Water Nozzle; Descale - DeLonghi ELETTA CAPPUCCINO EVO ECAM4686X Manual De Instrucciones

groove
hollow
30
5. Rinse inside the froth adjustment dial seat with running
water (fig. 31).
6. Check that the intake tube and spout are not clogged with
milk residues.
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube.
8. Place the lid back on the milk container.
Please note: washing by hand
Washing in a dishwasher guarantees the perfect hygiene of all
the milk container components. When washing by hand, wash
all components of the milk container thoroughly withhot water
and immerse them in a basin of hot water for 30 minutes before
proceeding as described in point 5.

11.11 Cleaning the hot water nozzle

Every now and then, clean the connection nozzle (A10) with a
sponge to remove milk residues from the gaskets (fig. 18).

12. DESCALE

Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• It is important to use De'Longhi descaler only. Using un-
suitable descaler and/or performing descaling incorrectly
may result in faults not covered by the manufacturer's
guarantee.
• Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler De'Longhi descaler
Container Recommended capacity: 2 l/67.63 fl oz
Time ~45min
Descale the machine when the corresponding message appears
on the display (B1). To descale immediately, press
and follow the instructions from point 6. To descale later, press
. (B2): on the display the
pliance needs descaling.
To access the descaling menu:
31
(B11)
symbol reminds you the ap-
1. Turn the appliance on and wait until it is ready for use;
2. Press to enter the "Settings" menu;
3. Press the scrolling arrows
"Maintenance" is displayed, then press
4. Press the scrolling arrows
ing" is displayed, then press
5. Confirm by pressing
6. (If the filter is installed): extract the water tank (A14), re-
move the water softener filter (C4) and empty the water
tank. Press
7. Pour the descaler into the tank up to level A (corresponding
to a 100ml pack) marked on the inner surface of the tank,
then add water (one litre) up to level B (fig. 32) and put the
water tank back. Press
8. Remove, empty and replace the drip tray (A19) and
grounds container (A17). Press
+
A
B
A
9. Place an empty container with a recommended capacity of
2 litres under the hot water spout (C6) and coffee spouts
(A9) (fig. 33). Press
Important! Danger of scalding
Hot water containing acid flows out of the coffee spouts and
hot water spout. Take care to avoid contact with splashes of this
solution.
10. The descale programme starts and the descaler liquid
comes out of the hot water and coffee spouts. A series of
rinses and pauses is performed automatically to remove all
the scale residues inside the coffee machine;
After about 25 minutes, descaling stops;
11. The appliance is now ready for rinsing through with clean
water. Empty the container used to collect the descaler
solution. Extract the water tank, empty, rinse under run-
ning water, fill with fresh water up to the MAX level and
put back in the appliance. Press
17
(B3) or
or
;
;
;
;
;
B
2l/67.63 oz
32
;
;
(B10) until
;
until "Descal-
33