Transport; Storage; Recycling And Machine Disposal - Garland GEISER 251 Manual De Instrucciones

9. TRANSPORT

Transport the machine only when the machine is
stopped.
Wait five minutes after the machine has been stopped
to ensure that the machine cools down before
transporting.
To transport, we strongly recommend that you remove
the entry and impulsion hoses.
Remember that this machine has no transport wheels
and you will have to transport the machine by the
main body. Check the weight of the machine in the
general characteristics to ensure that you can lift this
weight. Always transport the machine in a horizontal
position.
If you are going to transport the machine by car or
other vehicles, make sure the machine travels in a
stable position and hold the machine firmly so that it
does not slide when being transported.

10. STORAGE

Once the machine has been stopped, wait for five
minutes so that the machine cools down before
storing the machine.
The exhaust pipe will still be hot after the machine has
been turned off. Do not store the machine in a place
close to heat sources, inflammable products, dry
grass, wood, gases and petrol.
Store in a place which is inaccessible to children. The
machine once stored should be clean, on a flat and
dry surface and with no water in the interior of the
All manuals and user guides at all-guides.com
pump. Store in a place with a range of temperatures
not inferior to 0ºC and not above 45ºC and with a
humidity lower than 50%.
Clean all the pieces and store the machine in a secure
and dry place.
Check the maintenance chapter before storing.
If you are going to store the machine in a closed area,
empty the petrol and oil deposits as vapours could
cause a fire if near inflammable products.
Please store used oil in an adequate recipient for used
oil and take it to be recycled. Do not throw the oil
away into the sewage or the ground.
11. RECYCLING AND MACHINE
DISPOSAL
Get rid of your machine in an ecological
way. We should not get rid of the machine
with the domestic rubbish. Its plastic and
metallic parts can be clasified and can be
recycled.
All materials used to box this machine are
recycable. Please, do not dispose of the box
with your domestic rubbish. Throw these
parts in an official ecologial residual pick
up point.
31/100
English