Commissioning - Wilo MAXO Instrucciones De Instalación Y Funcionamiento

Commissioning

Connect cable:
ƒ
ƒ
ƒ
CAUTION
Risk of material damage!
In case there's no cable connected, and the cable connection is in the 12 o'clock
position, a dummy plug (accessory) shall close the connection in order to ensure IP
protection.
7.2.7 Wilo-Connectivity Interface
The Wilo-Connectivity Interface (Fig. I, Item 14) is intended to be used by Wilo only,
for production and service purposes.
WARNING
Risk of fatal electrical shock!
A sealing sticker protects the product from humidity and must not be removed.
Removing the sticker will invalidate the warranty!
Never put objects into the plug!
8 Commissioning
ƒ
ƒ
ƒ
ƒ
ƒ
CAUTION
A dry run leads to bearing damage!
Ensure that a dry run of the pump is not possible!
Installation and operating instructions Wilo-Para MAXO/-G/-R/-Z
Check the presence and integrity of the seal on the connector before installa-
tion.
Connect the SSM cable plug to the signal connection socket (Fig. I, Item 12) until
it snaps into place.
Ensure that the connecting cable does not contact either the pipes or the pump.
Electrical work: Electrical work must be performed by a qualified electrician.
Installation/dismantling work: The installation/dismantling must be carried out
by a qualified technician who is trained in the use of the necessary tools and fix-
ation materials.
The product must be operated by persons who are instructed on how the com-
plete system functions.
Prior to commissioning the pump, check that it has been installed and connected
correctly.
Ensure that the system is filled with a permissible fluid.
en
87