Displaying Saved Measurements - Beurer medical FT 90 Instrucciones De Uso

Hold the thermometer 2 to 3 cm from the measuring point. Press the
SCAN button and move the thermometer from side to side over the
forehead area (fig. 8).
During measurement you will hear short beeps (only if the acoustic sig-
nal is activated), which signal that the thermometer has found a new
highest measurement.
End of measurement is signalled by a long beep.
Release the SCAN button.
You can now read the measured value.
In addition to the temperature, the fever
play:
The no fever symbol
fever symbol indicates a measurement of over 38 °C, i.e. temperature alarm.
The measuring time is usually 2 seconds but may take up to 30 seconds.
The device is ready to take another measurement when two short beeps sound and the
forehead symbol
The measurement is automatically saved with the date/time and the "fever"
"no fever" classification.

6.1 Displaying saved measurements

The device only stores measurements in forehead temperature mode
matically stores the values from the last 60 measurements.
When 60 storage places are exceeded the oldest value is deleted.
The memory can be called up as follows:
• With the thermometer switched on, press and hold the MODE/MEM button for 5 seconds.
The most recent measurement is displayed.
• With each subsequent pressing of the MODE/MEM button, first the storage space num-
ber is displayed followed by the measurement upon release.
• In the upper line, the time and date are displayed alternately.
indicates that the body temperature is within normal range; the
stops flashing.
or no fever symbols also appear in the dis-
Fig. 8
/
. The device auto-
27